Xblast tools not working

Leaving this menu will revert all uncommitted changes. Decrypted Confounder 3. Decrypted HDD key 4. Decrypted Game Region 5. MAC Address 6. Serial Number 7. Online key. This entry bring out the on screen keyboard that will let the user change the console's network MAC address.

You will need to modify the motherboard to disable write protection on the TSOP flash chip. The process of preparing your motherboard depends on the revision of your console. In the case of my revision 1. Most consoles require this same modification any console from revision 1. The image above shows the locations of the pads. The solder pads are very small, but if you're patient and careful you should be able to heat both of the pads, and apply a little extra solder until the two pads are connected.

It can be hard to tell if you successfully made the connections. If you are unsure you can always put back together your Xbox, and continue with this guide. Unsuccessful soldering results in an error when flashing the TSOP chip, so if you encounter that error just attempt to solder the pads again. Now that your motherboard is prepared for flashing, you'll need to actually flash the TSOP chip. Begin by starting your softmodded Xbox to your custom dashboard, then insert and launch the Hexen DVD.

After a couple of minutes you should see the Hexen home screen below. Select that third option. You'll now see another menu, which is pictured below. Option 3. After you confirm your selection you'll see a new menu pictured below.

This is the most universal option since it works on all Xbox consoles from version 1. Now you'll see a menu where you are prompted to select a BIOS. My disc came with several versions of iND, X2, and Evox. Those letters correspond to drive letters that the hard drive is partitioned into. By selecting F and G you will be able to use an additional G partition for supporting larger hard drives. This slows down the boot process, but it's worth it for me. After flashing the console will power off, you should be able to turn it back on using the power button.

I have the same question Report abuse. Details required :. Cancel Submit. Toggle "Set time automatically" to off 5. Set the date and time manually.. You can rename the menu entries, remove unwanted lines ,modifying the existing command lines may produce Unexpected behaviour. If your TSOP is split, you might want to remove the line. Add the following line in the [BIOS] section of your evox. Updated Extra features Please select an item below to find information on the below features.

Tip: XBlast OS. Here are 2 suggestions of location for cutting the trace. Please refer to the schematic representation below for proper pin mapping It is normal and desired to leave pins labeled D0 to D3 on the LCD unconnected.